Just Flight Customer Service

Return to the Customer Service homepage

PA-28R Arrow III (for FSX/P3D)

Service Pack 2.4 (28/07/2017)

What is new in this update?

  • Prepar3D v4 compatibility added

Previous updates (included in this update):

SP 2.3
  • CFG files moved from panel folder to /AppData/JustFlight folder to address issues caused by Windows UAC

SP 2.2

A 'Cockpit Texture Switcher' tool has been added to the Start Menu, allowing you to switch between 'Standard' (existing) and 'Clean' (less worn/torn) virtual cockpit textures.

Note: The tool should not be used whilst the aircraft is loaded in Flight Simulator X/Prepar3D.


SP 2.1

  • Numerous improvements to FDE
  • RPM sound issue fixed
  • Improved compatibility with hardware (e.g. Saitek controls)
  • Oil pressure now drops when prop lever is used (a result of increased demand on oil system)
  • Increased RPM drop when carrying out magneto checks

SP 2

  • ADF gauge logic fixed
  • 'Refill Menu' option added to menu bar
  • FDE improvements
  • Sound-set improvements
  • VOR indicators still functioning when NAV radios are switched off - fixed
  • Manual PDF updated to reflect software changes since release

SP 1
  • Flight1 GNS integration added
  • Interactive engine start checklist added
  • FSUIPC auto-saves trigger panel state save - fixed
  • Option to disable 2D panel selector arrow added to PA-28 menu
  • “GPS changed. Updating HSI source…” message keeps appearing – fixed
  • Battery voltage low/oil quantity low message will now appear onscreen to warn of potential failures
  • Changes to engine start logic
  • Changes to fuel selector logic
  • Flaps not moving with electrical power off – fixed
  • Battery discharge and oil usage now occur only when engine management is enabled
  • Door now only closes fully when both latches are closed
  • Slight delay in electrical power availability after battery/alternator switched on, for added realism

For optimal performance we have now included a switcher tool (PA28 Arrow Model Switcher), located in the Start Menu, which allows you to switch between three cockpit variants:

  • No Flight1 GTN or GNS - features the KX 170 (COM1/NAV1) and GPS 100. This is the default option.
  • Flight1 GTN 650-750 model - integrated Flight1 GTN 650 and 750
  • Flight1 GNS 430-530 model - integrated Flight1 GNS 430 and 530

With either the Flight1 GTN or GNS models selected, you can switch between the available GPS options using the Add-ons > Just Flight PA28R Arrow III menu within your simulator.

Note: If you are using the Flight1 GNS, please make sure to toggle the 'navigation source' by clicking on the GNS' SD card to select the unit (GNS 430, GNS 530 or Flight Simulator GPS) which you are using. This will ensure that the autopilot navigation mode is using the correct source. Refer to the Flight1 documentation for more information.



The interactive engine start checklist can be accessed by clicking on the icon found in the lower left corner of the checklist panel when either the 'Before Start' or 'Engine Start' checklist is selected.

The checklist items will automatically turn from red to green when you have completed the associated check. The failures section displays the status of possible failures that will prevent engine starting. The failure items will automatically change from green to red if the associated failure occurs. Refer to the support FAQs and manual for more information on how to resolve each failure.

Didn't find the answer you were looking for?

Contact our Support team